Replace perc battery on a dell r620 duration.
Perc h700 battery replacement procedure.
Perc h700 modular cards shipped in poweredge blade systems have an integrated dimm module which cannot be removed.
1 unpack the dimm and follow all antistatic procedures.
I replaced a failed battery in a perc 5 i.
After that then simply remove and replace the battery.
All hard drives are connected to the h700 with two drives mirrored for the boot volume 4 drives in a raid 5 array for the data volume and 1 drive as a hot spare.
My h200 sas leads should be long enough assuming the connectors are suitable.
After installing the replacement battery getbbustatus started showing the battery as missing.
The server will be running of a ups.
I couldn t find any special battery replacement procedures in the manual so i just turned the system off and swapped them.
To replace my h200 that i flashed into it mode.
The original and replacements are the same dlu8735 model.
I forget you said you have an h310.
It s the same kit for the perc 5 6.
I know these things can come with battery backup and other leads do i need any of that.
But the sas cables are not the same and they are not cheap.
New 3 7v 7wh fr463 nu209 laptop battery replace for dell poweredge perc 5i 6i r710 h700 2950 2900 r410 r610 t410 t610 1900 1950 raid controller 4 6 out of 5 stars 3 17 99 17.
Do not attempt the following procedure on a perc h700 modular controller card.
Power back up normally.
Perc 6i sas cables are not compatibles with h700.
Finding a complete bundle is probably better for you edit.
Installing the dimm on a perc h700 caution.
I have a drive on hand to replace it but i m not clear as to the procedure for doing that.
Mounting the dimm support.
Enable charging and if the battery is charging positive current generate an internal log event â battery started chargingâ.
Is there anything else i need to get the h700 running.
The learn procedure is as follows.
Page 54 figure 4 10.
For a freshly inserted battery or for monthly scheduled re learns raid controller firmware ensures the battery gets completely charged before initiating a re learn.
One of the drives in the raid 5 array is in predictive failure status.
So for someone finding that post.
So no need for sas cables.
The configuration is stored within the controller and wont be lost by replacing the battery.